Almost here!

Last look at my living room not dominated by organ shaped wooden sculpture

Carpet is rolled back, furniture shoved to the side. I will have to figure out where it all goes. There are two small dollies where the console will go, to let me spin it around and get at the back while I perform surgery.  I'm not going to be able to work on it in the garage and then move it inside. The piano movers will put it there, and there it will stay until the heat death of the universe.

Next...

Comments

Post a Comment

Popular posts from this blog

Improving the Manuals

Image
 I've been practicing and playing on my work in progress for several months now. That is long enough to start revealing design flaws.  Specifically, my choice to hang the magnets underneath the key-sticks with magnetic tape.  Every so often, one wiggles loose and I get a cipher and/or a dead note. I thought fixing these would be simple but as it happens, they are very hard to get to, even on the Great where the bottom is exposed - there is a big iron beam right in the way.    The Swell isn't so bad - I can swing it up and get in and correct them, but to get at the Great I have to remove both manuals completely.  After a few of these, I I started thinking about my options. The choice to do it that way was driven by the existence of a part of the electric keying mechanism which I left in place because it was necessary to the proper touch of the keys. Each key-stick has a return spring, but also pushes a lever to make the electric contacts. That lever  has its own spring. The comb
Read more

What I have so far

Image
My console has been picked up from the dealer, but won't get delivered to me till next week. That gives me time to work on the electronics.  I have a working prototype of the midi scanner for the pedalboard. My plan is to hook up the pedalboard first - partly because I expect it to be easier, the mechanism is bigger, more accessible, and there's a lot less of them.  Mostly though I would really like to have a working pedalboard to play with while I'm working out what to do about the manuals and stops. My design uses an Metro Mini from Adafruit for the controller and a pair of MCP23017 port expander chips available from your favorite supplier. The cable connects to a usb port on my mac, which is running Hairless Midi Bridge I have small array of pushbuttons standing in for pedals and it works - when I push a button, the correct note sounds in Hauptwerk, Grand Orge, Garage Band, or whatever.  Woohooo! I will upload the code to github, but right now it's in
Read more

Unit Testing is my friend

Image
I've soldered all those wires and female headers onto my SAM units.   For once in my life, I'm going to do things the right way around and test all of them before installing them into the organ. I breadboarded a simple testing widget with male connectors matching the females on the SAM unites. The power and ground wires coming from off screen above are attached to the ASTRON SS-18 I got to power all these magnets. At the bottom is a UBEC 12v-5v converter for the LED. The circuit for the reed switch is entirely separate from the wiring for the magnets, so it can connect directly to the arduino running at a lower voltage than the magnets. I'm converting here to use just one power source, and avoid having to connect and program a microcontroller for a very simple test.  As you see, there are two little push buttons.  Push the left one and the stop flips on (down) and the green LED lights. Push the right one and it flips off (up) and the light goes out. Repeat a couple of t
Read more